[Dec-2017-New]Download Braindump2go 200-150 PDF and VCE Dumps for Free[Q47-Q57]
2017 Dec New Cisco 200-150 Exam Dumps with PDF and VCE Free Updated Today! Following are some new added 200-150 Questions:
1.|2017 New 200-150 Exam Dumps (PDF & VCE) 106Q&As Download:
2.|2017 New 200-150 Exam Questions & Answers Download:
A network uses on pair of Layer 3 switches for core and distribution purposes. Which design is this network using?
A. collapsed core
B. collapsed distribution
C. collapsed Layer 3 core
D. collapsed Layer 2-3
What describes how the 802.1Q protocol lactates the transmission of multiple Layer 2 networks on a single link?
A. adds 802.1Q tag information between the source MAC address and the Ether Type/Length fields
B. encapsulates the frame inside an 802.1Q tunnel
C. adds 802.1Q tag information between the preamble and the destination MAC address
D. encapsulates the packet inside an 802.1Q tunnel
E. transparently directs packets based on 802.1Q tags inside the header
Which address is valid in the data link layer of the OSI reference model?
Which two statements describe characteristics of IPv6 unicast addressing? (Choose two.)
A. Global addresses start with 2000::/3.
B. Link-local addresses start with FE00:/12.
C. Link-local addresses start with FF00::/10.
D. There is only one loopback address and it is ::1.
E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
The network administrator has been asked to give reasons for moving from IPv4 to IPv6. What are two valid reasons for adopting IPv6 over IPv4? (Choose two.)
A. no broadcast
B. change of source address in the IPv6 header
C. change of destination address in the IPv6 header
D. Telnet access does not require a password
Switch A has BPDU fitering configured on all active interfaces.
A second switch, Switch B, is connected to Switch A.
Which two actions will Switch A take when Switch B is connected to it? (Choose two.)
A. Switch A will not send any BPDUs.
B. Switch A will transition the port a normal spanning tree port.
C. Switch A will not accept any BPDUs
D. Switch A will errdisable the port.
E. Switch A will start sending BPDUs to Switch B.
An engineer is configuring a new MDS switch. The switch is powered on, the customer connects to the console, and the initial setup script is started.
Which two items can be configured during this setup process?
A. default port-channel mode
B. default port VSAN membership
C. default switch port interface state
D. default zone mode
E. default storage VDC
Which Cisco UCS power policy mode enables a configuration that can tolerate the loss of an input power circuit?
C. N+1 in normal mode
D. N+1 in high-density mode
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/chassis-install-guide/ucs5108_install.pdf (page 33)
What is the maximum working distance of a 1000BASE-ZE SFP transceiver when ordinary single mode fiber?
A. up to 70 kilometers
B. up to 40 kilometers
C. up to 550 meters
D. up to 10 kilometers
Refer to the exhibit. Which type of network communication is depicted?
A. 802.3 frame
B. TCP frame
C. Ethernet packet
D. UDP packet
Which protocol is supported when OSPFv2 is used as the routing protocol?